Rapid HALT – A Cost Effective Alternative to HALT

Rapid Highly Accelerated Life Testing or Rapid HALT is a reliability test method that is used to expose product weaknesses.  A Rapid HALT procedure is a modification of a Classical HALT procedure.  For more information about Classical HALT procedures, refer to the following blog articles:

A Rapid HALT is an abbreviated HALT, typically one day of tests, making it a great cost-effective solution for those seeking faster qualitative results.  Exposing a product to a Rapid HALT early in the design process can help reduce product development time and cost by enabling manufacturers to identify flaws or areas of improvement before it’s too late.

Rapid HALT’s are a good tool for assessing the reliability of different suppliers of components but can also be used to assess the reliability of less complicated products.  For example, DES has performed Rapid HALT’s to evaluate the reliability of different suppliers of power supplies, cooling fans, and LED’s.  DES has also performed a Rapid HALT to study different fastening methods in order to determine which was more robust.

DES Rapid HALT Profile
Figure 1. DES Rapid HALT Profile


Rapid HALT profiles may vary slightly depending on the product.  Figure 1 illustrates DES’s standard Rapid HALT profile.  Vibration levels are ramped up concurrently with hot and cold temperature cycles.  The stresses are increased until the practical limits of products have been reached.  Examples of practical limits include the melting temperature of solder joints or excessive softening of plastics.  These stress levels are obviously well beyond the scope of most product designs and that is ok.  The purposes of any HALT is time compression by applying higher-than-normal stress levels.  The user should not necessarily focus on what level of stress caused the problem, but should focus on improving the weak points in their product.

Many times our customers are surprised with the Rapid HALT results because the less expensive components perform better.  Thus our customers are able to apply a significant cost reduction to their products.  This results in increased profits and reduced warranty costs.

For more information on HALT or other testing services, contact DES or call 610.253.6637.

Share This:

2 thoughts on “Rapid HALT – A Cost Effective Alternative to HALT”

  1. Dear Sirs,

    What would be the typical required samples sizes and cost for a rapid HALT test?
    How many read points are conducted?

    Is there a possibility to gather activation energies on failure modes as well?

    Please advise

    1. Typical sample size = 3 to 6
      Read points vary and are typically customized for each test
      Rapid HALT does not yield activation energies

Leave a Reply

Your email address will not be published. Required fields are marked *